LYC Questions

Joe Matchette

I recently started using my LYC on my aerobars just so I can havemy current watts sitting right in front of my face.  Two questions:

• Can you pair the LYC to an ANT+ Speed/Cadence sensor?  I have tried w/o success using the method in the manual.  Hopefully someone knows another way.
• How do I get rid of the FULL message?

I am not using PowerAgent since all I am using the LYC for is a Cateye display of real time watts.  I use my Garmin 310XT for data recording and found it too inconvenient to try and watch my power numbers while the unit was on my wrist.

Thanks,

Joe

charris

Have you considered using the 310XT with the quick release kit?

Nemo Brauch

Yes- assuming it's a wireless LYC, you should be able to pair it with a speed/cadence sensor. But the only way I know how to do that is the way the manual indicates. I never really messed with it much and didn't bother with extra sensors- I just used the "Hub" estimated metrics.

You need to clear the memory to get rid of the FULL. If I remember correctly (double check your manual) you do this by pressing and holding the two buttons until the CLR message appears.

I also have a 310XT. I use it instead of the LYC. But I wear the Garmin on my wrist with the face of the watch on the inside of my wrist. This lets me easily see the power numbers with a very small turn of the wrist.

Spokane_Al

I used the hub to estimate my cadence and, after buying the separate cadence sensor, in comparing the two numbers found very little differences.